Changes between Version 11 and Version 12 of TBR/BSP/Mvme2100

Timestamp:

12/20/10 01:36:26 (13 years ago)

Author:

Danielcode

Comment:

/* Overview */

TBR/BSP/Mvme2100

@@ -22 +22 @@
 
 The MVME2100 is a Motorola VMEbus board.  It is a variable of the motorola_shared BSP.
+
+The MVME2100x is a single board computer (SBC) with support for PCI  mezzanine cards. It is based on the MPC8240 microprocessor.
+The right front panel cutout provides access to PMC I/O. One single-width  PMC can be installed.  The left front panel cutout provides access to Type II PC-MIP I/O (SCSI,  VGA, etc.) Up to two PC-MIP cards can be added.
+The center of the MVME2100 SBC can accommodate one Type I PC-MIP  card (on connectors P21, P22, and P23). It should be noted that any Type I PC-MIP card that does not incorporate I/O (such as flash memory)  can also be installed on the left side of the board where the Type II PC-MIP  cards are normally installed (on either P31/P32 or P41/P42)
+
+The PMC slot is shared with one of the PC-MIP Type I slots.  A factory build option determines whether the slot will  support a PMC board or a PC-MIP Type I board (i.e.  connectors P11/P12/P13 will be removed if the PMC board  is installed on J11/J12/J14) Two RJ45 connectors on the front panel provide the interface to  10/100Base-T Ethernet, and to a debug serial port
+
+The following list is of equipment that is appropriate for use in an  MVME2100 system:
+ *  PMCspan PCI expansion mezzanine module
+ *  Type I or II PC-MIP cards
+ *  Peripheral Component Interconnect (PCI) Mezzanine Cards (PMC)s 
+ *  VME system enclosure 
+ *  System console terminal 
+ *  Disk drives (and/or other I/O) and controllers 
+ *  Operating system (and/or application software)
 = Board Setup =