Mtx603e

{{Infobox BSP |BSP_name = MTX603e |Manufacturer = Motorola |image = Mtxppc.png |caption = |Board_URL = [References http://www.rtems.org/wiki/index.php/Mtx603e#References] |Architecture = PowerPC RISC |CPU_model = MPC603e |Monitor = uBoot, uMon |Simulator = Yes. Skyeye |Aliases = MTX603 |RAM = 16MB-256MB |NVMEM = 1+8M Flash |Serial = 4 x DTE ports (COM1 and COM2) |NICs = Ethernet DEC21143 10BaseT/100BaseTx |Other = LED-mezzanine/remote-reset connector }}

Overview

The MTX series motherboard consists of the MPC603e/604e processor, the Raven PCI Bridge and Interrupt Controller, the ECC Memory Controller Falcon chipset, 5M of Boot FLASH, ECC-protected DRAM, and a large set of I/O peripherals. The MTX will support single 603ev, single 604e processors, and dual 604e processors. In the dual processor configuration, the internal operating frequencies of the 604e’s are independently configurable. I/O peripheral devices on the PCI bus are: SCSI interface, Ethernet interface, two 64-bit PMC and one 64-bit PCI slot, or three 32-bit PCI slots.

Functions provided from the ISA bus are: two EIDE ports, a host mode P1284 parallel port, a peripheral mode P1284 parallel port, two async serial ports, two sync/async serial ports, a real time clock, and counters/timers. Rear panel connectors on the MTX motherboard include: a 6-pin circular DIN connector for the keyboard interface, a 6-pin circular DIN connector for the mouse interface, a 25-pin host mode parallel port connector, an RJ45 connector for 10/100BaseT connections, and a 15 pin connector for the AUI interface.

400px?

Board Setup

If there are special jumper or ROM monitor settings, describe them.

Downloading and Executing

Describe the download procedure.

Debugging

How do you debug code on this board? What gdb setup? BDM, stub, etc?

Test Reports

{{Test Report |Version = CVS head |Date = 7 Jan 2009 |User = User:JoelSherrill? |Report = reports that SkyEye? 1.2.5 can run most tests. }}

References

• ​mtxapg.pdf
• ​mtxaih1.pdf
• ​mtxpciih.pdf

{{Navbox_BSPs}}