- Timestamp:
-
12/17/11 06:10:35 (13 years ago)
- Author:
-
Ivaylo
- Comment:
-
Legend:
- Unmodified
- Added
- Removed
- Modified
-
v15
|
v16
|
|
1 | 1 | = LM3S6965 = |
2 | | |
3 | 2 | |
4 | 3 | = Overview = |
… |
… |
|
55 | 54 | * Reset push switch SW1 held down |
56 | 55 | * Internal debug mode—By the USB device controller (U4 FT2232) when instructed by debugger |
| 56 | = Power Supplies = |
| 57 | |
| 58 | The LM3S6965 is powered from a +3.3-V supply. A low drop-out (LDO) regulator regulates +5-V power from the USB cable to +3.3-V. +3.3-V power is available for powering external circuits. |
| 59 | A +15-V rail is available when the OLED display is active. The speaker and OLED display boost-converter operate directly from the +5-V rail. |
| 60 | = Debugging = |
| 61 | |
| 62 | Stellaris microcontrollers support programming and debugging using either JTAG or SWD. JTAG uses the signals TCK, TMS, TDI, and TDO. SWD requires fewer signals (SWCLK, SWDIO, and,optionally, SWO, for trace). The debugger determines which debug protocol is used. |
57 | 63 | = Block diagram = |
58 | 64 | |