Timeline



12/14/22:

23:26 Ticket #4724 (Git commit message format instructions) closed by Joel Sherrill
fixed: In a3d7dd1/rtems-docs: […]
23:25 Ticket #4725 (Git commit message format instrunctions (cloned)) closed by Joel Sherrill
fixed: In d144cf0/rtems-docs: […]
22:48 Changeset in rtems-docs [a3d7dd1] by Joel Sherrill <joel@…>
eng/vc-users.rst: Add commit message guidance Closes #4274.
22:11 Ticket #4774 (Port OpenThread to RTEMS) created by Joel Sherrill
OpenThread? is a BSD licensed IoT stack. Port it to RTEMS. …
20:10 Changeset in rtems [fd2f9d4] by Alex White <alex.white@…>
bsps: Import Xilinx GQSPI driver This adds Xilinx's driver for the Xilinx GQSPI controller embedded in the ZynqMP SoC. Within that device alone, it is possible to access this peripheral from MicroBlaze?, ARMv7, and ARMv8 cores. The imported files are and should be able to remain unmodified. Import information is kept in bsps/shared/dev/spi/VERSION.
18:05 Changeset in rtems-docs [d144cf0]55.25.3 by Joel Sherrill <joel@…>
eng/vc-users.rst: Add commit message guidance Closes #4275.

12/12/22:

22:05 Ticket #4773 (Can't build ATSAM BSP) created by Kyle Williams
I have been trying to build the BSP for the ATSAM architecture …

12/09/22:

09:20 Changeset in rtems [f845b95a] by Christian Mauderer <christian.mauderer@…>
bsp/atsam: Allow to use custom SDRAM With the old build system in RTEMS 5 that was possible by just overwriting BOARD_Sdram_Config and setting a custom ATSAM_MEMORY_SDRAM_SIZE during building the BSP. In the new build system that ATSAM_MEMORY_SDRAM_SIZE is set exclusively by the selected SDRAM chip. This patch adds the possibility to specify a "custom-0x100000" or similar as SDRAM type where the number gives the SDRAM size.
09:20 Changeset in rtems [7b968a2e] by Christian Mauderer <christian.mauderer@…>
bsps/atsam: Add NULL pointer protection
09:20 Changeset in rtems [26050b5f] by Christian Mauderer <christian.mauderer@…>
bsps/atsam: Fix unidirectional SPI transfers A SPI transfer where the Rx or Tx buffer is set to NULL currently transfers or overwrites data starting from address 0x00000000 via DMA. This patch changes the DMA setup so that dummy transfers are done. Just reading / writing to a single location is simpler than changing the whole logic of the transfer depending on the passed buffers.

12/07/22:

18:22 Ticket #4453 (Global vs Local Attribute Unclear for SMP/Distributed MP) closed by Joel Sherrill <joel@…>
fixed: In 32de9ff/rtems-docs: […]

12/06/22:

22:46 Ticket #4715 (RSB get sources misses a number of files) closed by Chris Johns
fixed: The release now fetches all sources.
22:45 Ticket #4704 (Fix invalid RSB source URLs) closed by Chris Johns
fixed: The release fetching of sources is now clean.
22:35 Ticket #4772 (Remove use of interval from rtems_task_wake_after() documentation) created by Chris Johns
The Classic API documentation for rtems_task_wake_after() refers to …

12/05/22:

23:25 Changeset in rtems [1c189e1a] by Kinsey Moore <kinsey.moore@…>
bsps/zynqmp: Fix and update device trees Add ref-clock-num identifiers to the device tree to ensure that interfaces use the correct clocks even when some are not used due to unconnected MII busses. This also adjusts the default ZynqMP PHY attachment to RGMII-ID which was the default before device trees were introduced.
04:57 Ticket #4771 (Versal UART issues) created by Chris Johns
The Versal polled mode it broken when building. The disable all …

12/04/22:

04:46 Ticket #4770 (Intel Specific x86-64 BSP Suport) created by blackbird
== Overview This ticket focuses on Intel related items that refine …

12/02/22:

18:19 Changeset in rtems [30ca711d] by Kinsey Moore <kinsey.moore@…>
bsps: Import Xilinx NAND driver This adds Xilinx's driver for the Xilinx NAND controller embedded in the ZynqMP SoC. Within that device alone, it is possible to access this peripheral from MicroBlaze?, ARMv7, and ARMv8 cores. This has been added to the hardware ZynqMP BSPs since QEMU does not support emulation of this peripheral. This driver supports polled operation only. The imported files are and should be able to remain unmodified. Import information is kept in bsps/shared/dev/nand/VERSION.
18:19 Changeset in rtems [50539ba8] by Kinsey Moore <kinsey.moore@…>
bsps: Import Xilinx support code This support code is necessary for many Xilinx-provided bare metal device drivers supported on ARM, AArch64, and MicroBlaze? platforms. Support for all of these architectures is kept under bsps/include due to multiple architecture variants being supported which requires complex logic in the build system. The imported files are and should be able to remain unmodified. Import information is kept in bsps/shared/xil/VERSION.
15:18 Ticket #4718 (Coverity issues in cpukit/libfs/src/ftpfs/tftpDriver.c) closed by Frank Kühndel <frank.kuehndel@…>
fixed: In 997ba1d9/rtems: […]
09:32 Changeset in rtems-source-builder [65f83cf] by Sebastian Huber <sebastian.huber@…>
tools: Fix thread names in rtems-record-lttng
09:14 Ticket #4769 (config: Add CONFIGURE_RECORD_INTERRUPTS_ENABLED) closed by Sebastian Huber <sebastian.huber@…>
fixed: In 47e1f6e/rtems-docs: […]

12/01/22:

18:13 Changeset in rtems-docs [32de9ff] by Joel Sherrill <joel@…>
c-user: Add Local vs Global to Key Concepts Chapter Add multiple new index entries and cite them where RTEMS_LOCAL and RTEMS_GLOBAL are cited. Closes #4453.
12:04 Changeset in rtems-docs [47e1f6e] by Sebastian Huber <sebastian.huber@…>
Document CONFIGURE_RECORD_INTERRUPTS_ENABLED Close #4769.
11:54 Changeset in rtems-central [492c2d4] by Sebastian Huber <sebastian.huber@…>
spec: Specify CONFIGURE_RECORD_INTERRUPTS_ENABLED Update #4769.
11:36 Ticket #4769 (config: Add CONFIGURE_RECORD_INTERRUPTS_ENABLED) created by Sebastian Huber
[…]
09:49 Changeset in rtems [71d1acd] by Sebastian Huber <sebastian.huber@…>
bsps/irq: Rename handler in dispatch table The name handler table was a bit misleading after the last rework. Rename it to distach table. Update the documentation accordingly. Update #4769.
09:22 Changeset in rtems [e012671] by Sebastian Huber <sebastian.huber@…>
aarch64/raspberrypi: Remove duplicate files These files are already provided by "../../objirq".
09:21 Changeset in rtems [c46fbb9] by Sebastian Huber <sebastian.huber@…>
config: Add CONFIGURE_RECORD_INTERRUPTS_ENABLED This enables the tracing of interrupt entry/exit events through an application configuration option. The interrupt processing can be viewed with Trace Compass using rtems-record-lttng from the RTEMS Tools. Update #4769.
07:55 Changeset in rtems [0d5e41a] by Sebastian Huber <sebastian.huber@…>
bsps/irq: Add bsp_interrupt_get_dispatch_table_slot() Update #4769.

11/30/22:

23:26 Ticket #4382 (mingw - add flex to packages needed) closed by Joel Sherrill <joel@…>
fixed: In 5a54847/rtems-docs: […]
23:26 Ticket #4766 (Classic API User Guide Index has Functions without Parentheses) closed by Joel Sherrill <joel@…>
fixed: In aaba6e5/rtems-docs: […]
21:00 Ticket #4768 (Use tarballs for stable versions development tools) created by Joel Sherrill
Currently many of the individual tools in the development toolchain …
20:56 Ticket #4767 (Add rtems-lwip to release packages) created by Joel Sherrill
The rtems-lwip repository is young but mature enough now to include in …
18:11 Changeset in rtems-tools [66b81d6] by Sebastian Huber <sebastian.huber@…>
record: Fix thread name handling Reset the thread name at thread create and ID events.
15:59 Changeset in rtems-docs [aaba6e5] by Joel Sherrill <joel@…>
c-user/*: Add trailing parentheses on methods in index which were missing it Closes #4766.
15:45 Ticket #4766 (Classic API User Guide Index has Functions without Parentheses) created by Joel Sherrill
Some index entries in the Classic API Users Guide has some method …
15:12 Changeset in rtems-docs [5a54847] by Joel Sherrill <joel@…>
user/hosts/windows.rst: flex needs to be installed for msys2 Closes #4382.
11:49 Ticket #4273 (Add a directive to report the RTEMS architecture) reopened by Sebastian Huber
utsname() uses CPU_NAME.
08:59 Ticket #4560 (Use thread-local storage for Newlib reentrancy objects) closed by Sebastian Huber
fixed: Yes, I recently were able to integrate the final patch for GCC 13. A follow up activity is #4765.
08:58 Ticket #4765 (Add constructor/destructor for thread-local objects) created by Sebastian Huber
See also: https://www.openwall.com/lists/libc-coord/2022/01/21/1
00:06 Ticket #4714 (Use waf for LwIP walk sources) closed by Kinsey Moore
fixed: This was resolved with commit e02d02e2ce29379c2d4bfb15fbd5b101e9bd58e8 to rtems-lwip.
00:05 Ticket #4756 (Docs build system does not build singlehtml (cloned)) closed by Chris Johns
fixed
Note: See TracTimeline for information about the timeline view.