Error compiling xilinx_zynq_zedboard.

[Arturo Pérez]

I encountered an error compiling the xilinx_zynq_zedboard BSP. I am using a built of the RSB that I compiled in December. With that built of the RSB I could built this BSP several times until I did a git pull of the RTEMS repo two weeks ago. Today I updated my repos of the RTEMS and RSB sources, I rebuilt the RSB and I tried to built again the xilinx_zynq_zedboard BSP, encountering the same error:

gmake[6]: * No rule to make target posix/include/sys/mman.h', needed by ../cpukit/../../../xilinx_zynq_zedboard/lib/include/sys/mman.h'. Stop.

[Gedare Bloom]

You need to re-build your toolchain with a new git-pull of the RSB.

[Arturo Pérez]

As I wrote, I updated the RSB sources by doing a git-pull. Then, I built it again, but using this new version I found the same error. I did it yesterday and today.

[Gedare Bloom]

The sys/mman.h was moved from RTEMS into newlib awhile ago, but maybe there is a problem with the integration. I recently added the mmap/munmap support. I'll try to look at this, can anyone else replicate it?

[Joel Sherrill]

I built all BSPs overnight and didn't have any failures due to this. I always bootstrap -c and rebootstrap before a build sweep. It is quite possible that the Makefile.in didn't get regenerated in the reporter's source tree.

[Gedare Bloom]

Yes, that makes sense. Arturo, please do bootstrap -c and then bootstrap, configure and make.

[Arturo Pérez]

Yes, that was the solution. I was not doing bootstrap -c.

From now I will do the built always following the steps as Joel said.

Thanks, so much. Sorry, if I made you losing a bit of time.

[Sebastian Huber]

Milestone renamed