# # $Id$ # Configuration Table Use ======================= sDeviceName The name of this device. deviceType This field must be SERIAL_Z85C30. pDeviceFns The device interface control table. This may be: + z85c30_fns for interrupt driven IO + z85c30_fns_polled for polled IO deviceProbe This is the address of the routine which probes to see if the device is present. pDeviceFlow This field is set to one of the following values: + NULL for no hardware flow control + z85c30_flow_RTSCTS for RTS/CTS based flow control + z85c30_flow_DTRCTS for DTR/CTS based flow control ulMargin This is currently unused. ulHysteresis This is currently unused. pDeviceParams This is set to the default settings. ulCtrlPort1 This field is the address of the control register for this port. ulCtrlPort2 This field is the address of the control register for chip. ulDataPort This field is the address of the data register for this port. getRegister setRegister These follow standard conventions. getData setData These follow standard conventions. ulClock This is the clock speed of the baud rate clock. NULL, then the CSR/ACR/X bit mappings shown in the 68681 and 88681 manuals are used. Otherwise, the board specific baud rate mapping is used. ulIntVector This is the interrupt vector number associated with this chip.