Ignore:
Timestamp:
Feb 27, 2009, 11:26:44 AM (12 years ago)
Author:
Thomas Doerfler <Thomas.Doerfler@…>
Branches:
4.10, 4.11, 5, master
Children:
949166d
Parents:
92cbf96
Message:
  • README: Added NCS.
  • Makefile.am, configure.ac, preinstall.am: Added BSP variants.
  • console/console-config.c, clock/clock-config.c, ssp/ssp.c: Fixed register settings. Cleanup.
  • include/bsp.h: Added network defines and functions.
  • include/lpc24xx.h: Added AHB and EMC defines. Fixed Ethernet status sizes.
  • include/system-clocks.h, misc/system-clocks.c: Added micro seconds delay function that uses Timer 1. Changed PLL setup.
  • network/network.c, startup/bspreset.c, startup/linkcmds.lpc2478, startup/linkcmds.lpc2478_ncs, startup/linkcmds.lpc2478_ncs_ram: New files.
  • startup/bspstart.c: Added EMC initialization. Changes for ROM boot.
File:
1 edited

Legend:

Unmodified
Added
Removed
  • c/src/lib/libbsp/arm/lpc24xx/README

    r92cbf96 r9647f7fe  
    88
    99Drivers:
     10
    1011        o Console
    1112        o Clock
    1213        o RTC
    1314        o SSP (SPI mode): This driver is in active development.  Use with care.
     15        o Network
     16
     17Howto setup QVGA Base Board?
     18
     19        o Unpack board.
     20        o Connect board via USB to your PC.
     21        o Verify that demo application runs.
     22        o Disconnect board.
     23        o Change jumpers to enable ISP.
     24        o Connect board.
     25        o Load U-Boot image 'u-boot_v1.1.6_lpc2468oem_v1_8_16bit.hex'
     26        (available from the EA support page) into the flash (flash tool
     27        FlashMagic is availabe from NXP).
     28        o Change jumbers back to disable ISP.
     29        o Use a terminal program to change the U-Boot settings via the console.
     30        o U-Boot settings:
     31                set ethaddr '00:1a:f1:X:X:X'
     32                set serverip 'X.X.X.X'
     33                set ipaddr 'X.X.X.X'
     34                set rtems 'tftp a1000000 lpc2478.img;bootm'
     35                set bootcmd 'echo Booting RTEMS ...;run rtems'
     36                saveenv
     37
     38Application Board: NCS (Nurse Control Station)
     39
     40        Board:      NextGenNCS
     41        Processor:  NXP LPC2478
     42        SDRAM:      8MByte, 16 bit wide
     43        Ext. Flash: 1MByte, 16 bit wide
     44        Console:    UART, 115200 Baud
     45        Network:    100Base-T
Note: See TracChangeset for help on using the changeset viewer.