Ignore:
Timestamp:
Aug 30, 2011, 1:58:05 PM (9 years ago)
Author:
Sebastian Huber <sebastian.huber@…>
Branches:
4.11, master
Children:
5be93c2
Parents:
c1188b41
Message:

2011-08-30 Peter Dufault <dufault@…>

  • make/custom/phycore_mpc5554.cfg, startup/linkcmds.phycore_mpc5554, network/if_smc.c: New files.
  • Makefile.am, preinstall.am: Reflect changes above.
  • configure.ac: Add support for the Phytec PhyCORE MPC5554. Includes:
    • HAS_SMC91111 to indicate a BSP has that neworking.
    • SMC91111_ENADDR_IS_SETUP so that it skips code to set up the MAC address.
    • MPC55XX_CLOCK_EMIOS_CHANNEL to permit one to set which eMIOS channel to use for the clock.
    • MPC55XX_BOOTFLAGS: Skips two words above the RCHW in the startup for use in skpping over the MMU setup. Required for debugging via a cheap emulator where code is loaded into RAM and then mapped in as flash.
  • BOARD_PHYCORE_MPC5554 If defined, use custom settings for the Phytec PhyCORE MPC5554 SOM.
  • clock/clock-config.c: Modify so that the EMIOS channel used for the clock can be selected at configuration time. For MPC5544 only:
    • Conditionally skip access to a register that faults if accessed on the MPC5554
    • Do not set the control register mode as was done for GW_LCFM support, it breaks interrupts.
  • make/custom/mpc55xx.inc: Make it possible to override the soft-float to set the type of floating point BSP will use.
  • startup/start.S: Add support for the "boot flags", two long-words that I manipulate with the debugger to skip over MMU setup. Use an external for the start of external SRAM instead of the hardwired number 0x20000000. Disable write access to the internal flash.
Location:
c/src/lib/libbsp/powerpc/mpc55xxevb/make/custom
Files:
1 added
1 edited

Legend:

Unmodified
Added
Removed
Note: See TracChangeset for help on using the changeset viewer.